Wanderlodge Owners Group

Wanderlodge Owners Group (https://www.wanderlodgeownersgroup.com/forums/index.php)
-   Forum Help (https://www.wanderlodgeownersgroup.com/forums/forumdisplay.php?f=41)
-   -   Clippered valve fittings on LXi (https://www.wanderlodgeownersgroup.com/forums/showthread.php?t=34826)

Scott White 09-14-2019 09:47 PM

Clippered valve fittings on LXi
 
Trying to find out if the fittings on the outlet side of the Clippered valve that go to the air valves to dump air bags on the chassie and tag are 1/16” pipe thread or 10-32 thread that screw into the Clippered. They offer both and and when you measure the part I broke and a 10-32 screw it is real close.

brhodes 09-14-2019 10:27 PM

Small fittings are normally 10-32" for the 1/8" tubing


Catalog URL
https://www.clippard.com/downloads/P.../New%20Catalog

Randy Dupree 09-14-2019 11:50 PM

Barrys right.

Scott White 09-15-2019 04:24 AM

Thanks a lot, I was leaning that way because it did have a plastic washer on it.
I will have a few extras as I think I have to order a pack of 10.

brhodes 09-15-2019 07:35 AM

Order new washers from Clippard also as they are not nylon. They normally cannot be reused.

Scott White 09-15-2019 08:03 AM

Barry
The fittings I ordered showed they come with the ring on them, I hope they do as I did not see any rings offered. I will go back and look.

brhodes 09-15-2019 10:37 AM

Check here for information on the .240" gaskets:
https://clippard.com/search/all/gaskets


All times are GMT -4. The time now is 03:27 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.