Wanderlodge Owners Group  
BuyByeBlueBird.com
Donate

Go Back   Wanderlodge Owners Group > Search Forums

Site Search:
Showing results 1 to 25 of 229
Search took 0.01 seconds.
Search: Posts Made By: mose
Forum: Electrical 1 Week Ago
Replies: 8
Views: 279
Posted By mose
Could there be an indicator lamp somewhere that...

Could there be an indicator lamp somewhere that shows when the pump is on? that would provide another source to feed the +12V to the 'gnd' wire for the pump. It would be such a low current that it...
Forum: Under The Awning 4 Weeks Ago
Replies: 18
Views: 499
Posted By mose
I would definitely disconnect it. Mainly because...

I would definitely disconnect it. Mainly because my first thought was that it could be an outside urinal......
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 10-10-2019
Replies: 23
Views: 985
Posted By mose
Did it ignite and get warm at all? I think after...

Did it ignite and get warm at all? I think after 3 ignite cycles it will fault if no ignition. You should be able to hear it trying to ignite. If you can hear it try to ignite for 3 cycles and...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 10-10-2019
Replies: 23
Views: 985
Posted By mose
Pic...

Pic...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 10-10-2019
Replies: 23
Views: 985
Posted By mose
Sounds like it's not igniting. If it was trying...

Sounds like it's not igniting. If it was trying to ignite, I think it would eventually set the fault light. A common problem with these is small thermal overload switch that is in the output line...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 10-10-2019
Replies: 23
Views: 985
Posted By mose
Assuming the '91PT is the same as a '91WB..... ...

Assuming the '91PT is the same as a '91WB.....

Yes, 2 boilers, Right and Left sides. However one of the sides also includes a loop for the domestic water heater. There is a 'summer/winter' valve...
Forum: General 10-02-2019
Replies: 11
Views: 3,153
Posted By mose
I believe there's also an air pressure switch...

I believe there's also an air pressure switch that will automatically extend the step when the air pressure drops below something like 50lbs. The same pressure switch may prevent retraction as well....
Forum: PARTS OR OTHER ITEMS FOR FREE 08-29-2019
Replies: 2
Views: 773
Posted By mose
I'd love to have one of the control boards from...

I'd love to have one of the control boards from the roof unit. One of mine is dead and I'm still trying to nurse these old units for a few more years.

And a spare fan motor would probably be a...
Forum: PT & WB (Twin Axle Pusher Unique Issues) 08-06-2019
Replies: 12
Views: 1,060
Posted By mose
What is this sock filter you speak of? I want to...

What is this sock filter you speak of? I want to pre-filter the oil when I change mine out with 10-30 and this seems like a great option.
Forum: PT & WB (Twin Axle Pusher Unique Issues) 06-17-2019
Replies: 15
Views: 1,667
Posted By mose
The roof vent can serve as the sink vent as long...

The roof vent can serve as the sink vent as long as it's not too far away from the P-trap in the sink. The distance depends on the pipe diameter (and slope). For 1.5" pipe, it's about 5'. So if...
Forum: PT & WB (Twin Axle Pusher Unique Issues) 06-12-2019
Replies: 15
Views: 1,667
Posted By mose
In my '91 I've found 2, one on each side...

In my '91 I've found 2, one on each side (although I think my kitchen sink drains into the black tank). The one under the bathroom sink was where I would expect, right next to the sink, up high. ...
Forum: PT & WB (Twin Axle Pusher Unique Issues) 06-11-2019
Replies: 6
Views: 379
Posted By mose
When I replaced the seal on mine, some of them...

When I replaced the seal on mine, some of them were a little tight, so I just put washers under the head of the female/fixed body that stays with the bus. Don't know if that helps or not.....
Forum: Electrical 04-30-2019
Replies: 25
Views: 1,600
Posted By mose
I'm a fan of crimp and solder. Then crimp only. ...

I'm a fan of crimp and solder. Then crimp only. But not solder only. The risk is that if you get a high current draw, the heat can cause the solder to melt. If there is no crimp, then the wire...
Forum: Under The Awning 04-30-2019
Replies: 9
Views: 560
Posted By mose
Russian listening device. Batteries and a...

Russian listening device.


Batteries and a switch. Fell out of a small penlight?
Forum: Electrical 04-24-2019
Replies: 8
Views: 473
Posted By mose
Newer GFCIs are also more sensitive. As older...

Newer GFCIs are also more sensitive. As older ones get replaced, the problems increase.

As was mentioned, unplug the instant hot under the sink. There should also be a switch to turn it off, but...
Forum: Electrical 03-13-2019
Replies: 4
Views: 563
Posted By mose
The high amp contact disk is not hard connected...

The high amp contact disk is not hard connected to the end of the bendix solenoid, but rather has a stiff spring to allow it to 'float' on the contacts. Then there is a weak spring to help push it...
Forum: Under The Awning 03-11-2019
Replies: 13
Views: 1,697
Posted By mose
I think the old design had a thinner seal and the...

I think the old design had a thinner seal and the newer thick seal also requires a new flapper to offset the thickness. Otherwise it won't sit flush. And you also risk breaking the plastic cam with...
Forum: Tires, Wheels, Brakes, Steering and Suspensions 02-22-2019
Replies: 220
Views: 25,317
Posted By mose
Randy, Totally appreciate your perspective. ...

Randy,

Totally appreciate your perspective. A reweld could fail again. And some people don't want the risk/liability. So your opinions are valued. Others are either willing to accept the risk...
Forum: Tires, Wheels, Brakes, Steering and Suspensions 02-22-2019
Replies: 220
Views: 25,317
Posted By mose
I wouldn't be afraid to weld it either. Consider...

I wouldn't be afraid to weld it either. Consider that it was cut and welded at BB to begin with. But I wouldn't try a repair in-place. Remove, clean, fixture, weld, reinforce.

That failure...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 02-01-2019
Replies: 66
Views: 22,360
Posted By mose
If anyone has a DEAD one, I'd like to try to...

If anyone has a DEAD one, I'd like to try to reverse engineer one to see what components are in them and what it would take to repair them or modify for external control or modification with...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 01-29-2019
Replies: 4
Views: 687
Posted By mose
I'm pretty sure the over-temp will prevent it...

I'm pretty sure the over-temp will prevent it from trying to start. I think it is in series with the main feed.

If it's clicking, then it's trying to light. If it doesn't light after a few...
Forum: Engine 01-18-2019
Replies: 8
Views: 970
Posted By mose
I second the 'low battery' comment. Bad...

I second the 'low battery' comment. Bad batteries or poor wiring or poor connections cause low voltage, which results in excessive current. This burns/melts the contacts on the solenoid and the...
Forum: Electrical 09-28-2018
Replies: 85
Views: 15,525
Posted By mose
That doesn't look factory. Does the coach still...

That doesn't look factory. Does the coach still have the factory 'AUX BATTERY' solenoid, or is this its replacement?

The factory AUX BATTERY solenoid had two functions, one was to provide...
Forum: LX and LXI (Unique Issues) 09-18-2018
Replies: 14
Views: 2,130
Posted By mose
Ah. That's the answer I was looking for.

Ah. That's the answer I was looking for.
Forum: LX and LXI (Unique Issues) 09-17-2018
Replies: 14
Views: 2,130
Posted By mose
Nice. I've thought of doing exactly this for...

Nice. I've thought of doing exactly this for those emergency clearance situations.

Since the cylinder is single acting, what retracts it? Is it spring loaded? I didn't think that the HCVs...
Showing results 1 to 25 of 229

 
Forum Jump
Web Search:

All times are GMT -4. The time now is 03:07 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.