Wanderlodge Owners Group  
BuyByeBlueBird.com
Donate

Go Back   Wanderlodge Owners Group > Search Forums

Site Search:
Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: gcyeaw
Forum: Electrical 13 Hours Ago
Replies: 6
Views: 176
Posted By gcyeaw
Mike checked it out and sure enough, someone ran...

Mike checked it out and sure enough, someone ran a hot lead to the switch bypassing the drawer switch :D
Forum: Electrical 14 Hours Ago
Replies: 6
Views: 176
Posted By gcyeaw
I looked over all the doc I have and can't find...

I looked over all the doc I have and can't find the circuit for the micro switch on the draw latch. If the draw is latched it should turn out the dash draw-open warning light and, I believe, disable...
Forum: Generators 2 Days Ago
Replies: 9
Views: 171
Posted By gcyeaw
Sounds like a flakey electric fuel pump. Cheap...

Sounds like a flakey electric fuel pump. Cheap and easy to replace. Or the power to the pump is flakey.
Forum: General 3 Days Ago
Replies: 10
Views: 472
Posted By gcyeaw
Place a couple of CO detectors to be sure the air...

Place a couple of CO detectors to be sure the air is safe. Breezes outside can push the CO right back in.
Forum: Under The Awning 6 Days Ago
Replies: 4
Views: 243
Posted By gcyeaw
What ever you do, don't take the red pill:D

What ever you do, don't take the red pill:D
Forum: Under The Awning 1 Week Ago
Replies: 6
Views: 297
Posted By gcyeaw
It was just outside the door, so why bother to...

It was just outside the door, so why bother to put my shoes on?:D
Forum: Under The Awning 1 Week Ago
Replies: 6
Views: 297
Posted By gcyeaw
Installer short on brains

I am preparing to install a used mobility scooter lift on my Jeep. Got the receiver hitch installed, but the mental midget that installed the lift for the PO misread the instructions, chose the wrong...
Forum: Under The Awning 1 Week Ago
Replies: 21
Views: 1,076
Posted By gcyeaw
It's out:D A lot of back and forth with a good...

It's out:D A lot of back and forth with a good impact gun after soaking in PB Blaster did the trick. But it sure felt like it was ready to snap, but didn't.
Forum: Under The Awning 1 Week Ago
Replies: 26
Views: 1,074
Posted By gcyeaw
Don't worry Randy, most of the jobs have been...

Don't worry Randy, most of the jobs have been de-skilled to the point where you don't need much education to do them (folks at auto parts places for example)
Forum: Under The Awning 1 Week Ago
Replies: 4
Views: 299
Posted By gcyeaw
fast mobility scooter

I think this might make for a decent performance scooter

https://www.youtube.com/watch?v=gWYRhaOd1PE
Forum: Under The Awning 1 Week Ago
Replies: 21
Views: 1,076
Posted By gcyeaw
Of course I could cheat:D I am using it for a...

Of course I could cheat:D I am using it for a mobility scooter lift, not a 5000 pound trailer. I could just enlarge the hole in the hitch so it fit over the head of the problem bolt and have 5...
Forum: Under The Awning 1 Week Ago
Replies: 21
Views: 1,076
Posted By gcyeaw
If it snaps off, drilling and taping would be the...

If it snaps off, drilling and taping would be the next option. Hope it doesn't end up that way.
Forum: Under The Awning 1 Week Ago
Replies: 21
Views: 1,076
Posted By gcyeaw
Lots of good suggestions, Thanks. This is not my...

Lots of good suggestions, Thanks. This is not my first rodeo, but it is always nice to get some suggestions to think about. Right now it is snowing, or raining, so it will be a couple of days before...
Forum: Under The Awning 1 Week Ago
Replies: 14
Views: 588
Posted By gcyeaw
Feel better my friend!

Feel better my friend!
Forum: PT & WB (Twin Axle Pusher Unique Issues) 1 Week Ago
Replies: 10
Views: 574
Posted By gcyeaw
Warm it up with a hair dryer or carefully with a...

Warm it up with a hair dryer or carefully with a heat gun. It will flex easier and snap on with much less effort.
Forum: Under The Awning 1 Week Ago
Replies: 21
Views: 1,076
Posted By gcyeaw
The nut was welded to the inside of the frame,...

The nut was welded to the inside of the frame, then it was assembled. No access to replace it without making a big hole and welding it up again...not the best way so far!
Forum: Under The Awning 1 Week Ago
Replies: 21
Views: 1,076
Posted By gcyeaw
frozen bolt

I need to put a receiver hitch on my Jeep for a mobility scooter lift I got off Craig's list
...
Forum: Electrical 1 Week Ago
Replies: 3
Views: 335
Posted By gcyeaw
Bird gennies run at 1800 RPM, this one needs...

Bird gennies run at 1800 RPM, this one needs 3600, louder than LOUD.
Forum: Tires, Wheels, Brakes, Steering and Suspensions 2 Weeks Ago
Replies: 17
Views: 619
Posted By gcyeaw
If it was a brake light switch it would only leak...

If it was a brake light switch it would only leak when the brakes were applied. Was your pic taken with the brakes applied?
Also some pressure switches have an internal ground (one wire) and others...
Forum: Tires, Wheels, Brakes, Steering and Suspensions 2 Weeks Ago
Replies: 14
Views: 555
Posted By gcyeaw
Check the laws in the states you may pass...

Check the laws in the states you may pass through. Some require chains on certain roads/grades, and I don't know if they will accept this product. Might end up the opinion of the local police/DOT...
Forum: Vehicle Issues 3 Weeks Ago
Replies: 11
Views: 581
Posted By gcyeaw
I had a major vibration after a tranny swap on my...

I had a major vibration after a tranny swap on my old FC and it turned out to be bad bearings in a U joint. The incompetent shop messed them up re-installing them. I loved the retarder in my 83 FC.
Forum: Electrical 3 Weeks Ago
Replies: 5
Views: 302
Posted By gcyeaw
Most of the circuits use breakers. Some fuses...

Most of the circuits use breakers. Some fuses are used for certain things that I assume could present a problem with a resetting breaker (like the panel in the kitchen area). Those auto reset...
Forum: Electrical 3 Weeks Ago
Replies: 5
Views: 302
Posted By gcyeaw
What is the issue, front and rear both failing?...

What is the issue, front and rear both failing? On my 86 PT the flasher is under the dash on the left side. I'll try to find the breaker on my diagrams.

On mine breaker 22 in the lower front load...
Forum: General 3 Weeks Ago
Replies: 9
Views: 608
Posted By gcyeaw
Yup, forgot to mention you can't dump the main...

Yup, forgot to mention you can't dump the main suspension if the tag is still up. Prevents you from putting the entire coach rear weight on the tag alone.
Forum: 'Bird Projects & Modifications 3 Weeks Ago
Replies: 990
Views: 78,447
Posted By gcyeaw
I had a Proheat in my 83 FC. Great for warming...

I had a Proheat in my 83 FC. Great for warming the engine and the coach. But, that 'low rumble' tends to find anything that is in an inaccessible place to produce a sympathetic rattle:eek:

The...
Showing results 1 to 25 of 500

 
Forum Jump
Web Search:

All times are GMT -4. The time now is 04:31 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.