Wanderlodge Owners Group  
BuyByeBlueBird.com
Donate

Go Back   Wanderlodge Owners Group > Search Forums

Site Search:
Showing results 1 to 25 of 500
Search took 0.03 seconds.
Search: Posts Made By: Dan & Cindy
Forum: M380 (Unique Issues) 10-13-2019
Replies: 53
Views: 2,784
Posted By Dan & Cindy
Do you have 120 VAC at the pressure switch?

Do you have 120 VAC at the pressure switch?
Forum: How To Protect Your RV Investment. 10-10-2019
Replies: 10
Views: 659
Posted By Dan & Cindy
I had a minor diesel leak a few years ago. I was...

I had a minor diesel leak a few years ago. I was able to cure it by tightening the fasteners that hold the housing together. I think the low sulfur diesel may have contributed to gasket shrinkage.
Forum: M380 (Unique Issues) 10-09-2019
Replies: 7
Views: 252
Posted By Dan & Cindy
I've posted detailed instructions a few years...

I've posted detailed instructions a few years ago. Will try to find them but from memory you will need to:
1. remove the lower cover held in place by the four snap latches
2. disconnect...
Forum: M380 (Unique Issues) 10-04-2019
Replies: 17
Views: 794
Posted By Dan & Cindy
If your rebuild is like mine, you may need to cut...

If your rebuild is like mine, you may need to cut off some bolt heads and replace some of the rivnuts that are spinning in the sheet metal enclosure.
Forum: M380 (Unique Issues) 10-02-2019
Replies: 2
Views: 289
Posted By Dan & Cindy
Mine is the same as Lance's. You will have to...

Mine is the same as Lance's. You will have to remove the components to get to it. Mine has blown its internal fuse a couple of times.
Forum: Parts Wanted 08-21-2019
Replies: 2
Views: 265
Posted By Dan & Cindy
If you can't a replacement, send my your email...

If you can't a replacement, send my your email and will send some photos and dimensions for mine. Shouldn't be too difficult to make the frame and cover with padding and upholstery of your choice.
Forum: M380 (Unique Issues) 08-09-2019
Replies: 133
Views: 5,051
Posted By Dan & Cindy
I am the M380 owner who added an analog oil...

I am the M380 owner who added an analog oil pressure gauge in the engine compartment because I didn't trust the digital data and the dash gauge. The dash oil pressure gauge always dropped to a very...
Forum: M380 (Unique Issues) 05-22-2019
Replies: 38
Views: 4,540
Posted By Dan & Cindy
Keep us posted.

Keep us posted.
Forum: M380 (Unique Issues) 05-16-2019
Replies: 27
Views: 1,094
Posted By Dan & Cindy
I built an over-engineered mount from aluminum...

I built an over-engineered mount from aluminum plate and bar stock for the Samsung that replaced the original Plasma monitor. I salvaged the original mounting posts, sockets and locking bars so...
Forum: M380 (Unique Issues) 05-16-2019
Replies: 4
Views: 219
Posted By Dan & Cindy
Jim, I feel your pain and hope I can help. ...

Jim, I feel your pain and hope I can help.

The thermostat does have a built in delay but I think it is only a couple of minutes. Since you can control the front unit's fan, I would rule...
Forum: M380 (Unique Issues) 05-13-2019
Replies: 6
Views: 436
Posted By Dan & Cindy
I used the GE whole house cartridge. Home Depot...

I used the GE whole house cartridge. Home Depot has different versions to choose from which are all about 9.8" long x 2.7" in diameter: FXWTC has carbon to remove taste and odor and FXWSC to remove...
Forum: M380 (Unique Issues) 05-12-2019
Replies: 6
Views: 436
Posted By Dan & Cindy
I found ones that fit at my local Home Depot.

I found ones that fit at my local Home Depot.
Forum: M380 (Unique Issues) 05-09-2019
Replies: 6
Views: 594
Posted By Dan & Cindy
My air dryer is tucked between the radiator and...

My air dryer is tucked between the radiator and rear tires. It is shown in the attached schematics.
Forum: M380 (Unique Issues) 04-18-2019
Replies: 22
Views: 3,279
Posted By Dan & Cindy
Leaking Microphor - mine has leaked a couple of...

Leaking Microphor - mine has leaked a couple of times. I traced it down to the two threaded studs that hold the hopper to the bowl. A gentle tightening of the nuts solved the problem without having...
Forum: M380 (Unique Issues) 04-09-2019
Replies: 27
Views: 2,522
Posted By Dan & Cindy
I got lucky with the rear brakes. There were a...

I got lucky with the rear brakes. There were a few very shallow heat checks in the rotors. I was unable to get replacement rotors in a reasonable time so I had the original ones turned to remove...
Forum: M380 (Unique Issues) 03-26-2019
Replies: 9
Views: 650
Posted By Dan & Cindy
Been too long to recall exactly what I did, but a...

Been too long to recall exactly what I did, but a remember a couple of cans of WD-40 or your favorite aerosol lubricant sprayed and lots of repetitive motion ultimately freed the latching bar.
Forum: M380 (Unique Issues) 03-26-2019
Replies: 27
Views: 2,522
Posted By Dan & Cindy
Searching for 2004 M380 rear rotors

My parking brake was dragging and has caused the rear brakes to heat up, damage the pads and perhaps damaged the rotors. Should know more tomorrow.

I have heard that minor cracks in the rotors...
Forum: M380 (Unique Issues) 01-16-2019
Replies: 83
Views: 7,185
Posted By Dan & Cindy
Thanks for the suggestion. Sears has a few...

Thanks for the suggestion. Sears has a few Samsung RF18 on their website but they are listed as floor models or with cosmetic damage. I want to buy a new, out of the box model.
Forum: M380 (Unique Issues) 01-15-2019
Replies: 83
Views: 7,185
Posted By Dan & Cindy
Looks like my Dometic gave up last week. I will...

Looks like my Dometic gave up last week. I will be joining those who've installed Samsung refrigerators.
Forum: M380 (Unique Issues) 01-09-2019
Replies: 17
Views: 811
Posted By Dan & Cindy
I've experienced the light gap on my M380 that I...

I've experienced the light gap on my M380 that I think it was caused by a sticking solenoid valve. I disconnected the control wires and reconnected them. It seemed to solve the problem.
Forum: M380 (Unique Issues) 01-04-2019
Replies: 62
Views: 9,482
Posted By Dan & Cindy
Hurricane circulation pump motor brush replacement

Doug, I have replaced the circulation pump brushes in-situ several times. Its location at the lower left rear corner of the Hurricane makes access difficult but it can be done. It is a little messy...
Forum: M380 (Unique Issues) 12-31-2018
Replies: 28
Views: 1,943
Posted By Dan & Cindy
I also had a near miss with a hole in the muffler...

I also had a near miss with a hole in the muffler in my M380 a few years. No smoke was externally visible but the temperature of the exhaust chase inside the cabinet was higher than normal at about...
Forum: Vehicle Issues 12-28-2018
Replies: 24
Views: 5,093
Posted By Dan & Cindy
Hey M380 Gearheads – I need your help

I started up my M380 today for the first time since mid-September and noticed something new. The amber low coolant level indicator on the dash was dimly flickering (see first photo) but there was no...
Forum: M380 (Unique Issues) 12-03-2018
Replies: 2
Views: 252
Posted By Dan & Cindy
I have added cable operated dump valves in the...

I have added cable operated dump valves in the two ports on the front tank Jim described. I periodically actuated them and have never found any water in this tank.
Forum: General 11-27-2018
Replies: 6
Views: 525
Posted By Dan & Cindy
Welcome! We live in Broussard, LA so are...

Welcome! We live in Broussard, LA so are neighbors.
Showing results 1 to 25 of 500

 
Forum Jump
Web Search:

All times are GMT -4. The time now is 08:00 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.