Wanderlodge Owners Group  
BuyByeBlueBird.com
Donate

Go Back   Wanderlodge Owners Group > Search Forums

Site Search:
Showing results 1 to 25 of 141
Search took 0.01 seconds.
Search: Posts Made By: ryoung
Forum: General 07-20-2015
Replies: 3
Views: 1,226
Posted By ryoung
Key Number

Just a thought but still working on this problem. Does anyone know the key number for their lower bay doors on an 1981 FC? There is a possibility that they were all the same. I could get one to...
Forum: 'Bird Projects & Modifications 03-09-2015
Replies: 8
Views: 1,997
Posted By ryoung
Unable to find proper cam locks

I have been trying to replace broken and worn cam locks for my lower compartments. All of the ones I have found have a screw or a bolt holding the cam in place that make them too long. Has anyone...
Forum: General 11-23-2014
Replies: 3
Views: 1,226
Posted By ryoung
Locks for bay doors inside paddle handles

I am looking to change all of the locks on my bay doors on my 1981 FC. Has anyone done this? They look a bit challenging as the locks are inside the paddle handle. I am looking to change all 6 of...
Forum: FC (Forward Control Unique Issues) 09-08-2014
Replies: 30
Views: 5,495
Posted By ryoung
Fuel Additives

Have a question. I purchased the Lucas fuel additive. Went to put it in my tank and there is a decal on the flap that says "This vehicle equipped with a Racor fuel filter. Do not use fuel...
Forum: General 08-05-2014
Replies: 6
Views: 1,205
Posted By ryoung
I used the small wheel that Napa sells for...

I used the small wheel that Napa sells for removing decals. Still takes some time and elbow graese but results in a much better job. It will take you about 8 - 10 of these wheels. Good Luck! I...
Forum: FC (Forward Control Unique Issues) 04-16-2014
Replies: 4
Views: 1,113
Posted By ryoung
Drapery carrier for rear curtain

My wife is trying to make new curtains for the rear window of our bird. Does anyone know where to get the small plastic carriers that go in the track? As we have a rear bedroom coach, the track is...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 12-26-2013
Replies: 1
Views: 1,749
Posted By ryoung
Installing Roof AC

At present I have cruise airs. For the front unit the compressor is gone and there is a leak on the condensor coils. I was going to replace with a roof air throough the vent in the living room...
Forum: Engine 10-31-2013
Replies: 54
Views: 16,210
Posted By ryoung
So I left the cat for a week and tried to start...

So I left the cat for a week and tried to start it, it would not fire. I cannot find any place where there appears to be a fuel / vacumm leak in the line, but I would imagine they would be very hard...
Forum: Electrical 10-18-2013
Replies: 9
Views: 1,426
Posted By ryoung
So I have searched both under the sink and where...

So I have searched both under the sink and where the manual electrical input selector switch is, not in either of these areas. Mine is a side bath with cruise airs. When I was working on the Middle...
Forum: Electrical 10-17-2013
Replies: 9
Views: 1,426
Posted By ryoung
I cannot find it under the sink. Any other...

I cannot find it under the sink. Any other ideas?

Thanks
Forum: Electrical 10-15-2013
Replies: 9
Views: 1,426
Posted By ryoung
Redi Line circuit transfer switch

Does anyone know where the transfer switch is located for the redi-line / inverter circuit that supplies the power to the ice maker? Mine will not work off of the inverter side of the power, and I...
Forum: Engine 10-15-2013
Replies: 54
Views: 16,210
Posted By ryoung
Any ideas on above issue? Help would be...

Any ideas on above issue? Help would be appreciated.

Thanks
Forum: Engine 10-14-2013
Replies: 54
Views: 16,210
Posted By ryoung
I am having what seems to be a similar issue with...

I am having what seems to be a similar issue with my bird. We went camping this weekend, everything ran perfect getting there. When it was time to go, the bird started perfectly. As it was sitting...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 07-04-2013
Replies: 24
Views: 2,238
Posted By ryoung
I have checked the wiring and I have power to the...

I have checked the wiring and I have power to the condensor side of the AC unit. The fan there is working. Just need to somehow see if it is the starter / capacitor / or compressor itself.
...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 07-03-2013
Replies: 24
Views: 2,238
Posted By ryoung
Thanks for the diagram. Mine was missing. The fan...

Thanks for the diagram. Mine was missing. The fan works fine, just cannot feel the compressor working. I am not sure how the starter works, and if it can be tested. I would assume if the start...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 07-03-2013
Replies: 24
Views: 2,238
Posted By ryoung
Cruise air conpressor not working

I am trying to work on my cruise air that has not worked since I have owned my Wanderlodge. On the condensor side, the fan works, but the compressor does not run. It does not trip the breaker, just...
Forum: FC (Forward Control Unique Issues) 03-24-2013
Replies: 28
Views: 9,257
Posted By ryoung
When I installed mine, I talked to Jacobs for...

When I installed mine, I talked to Jacobs for some reason (I forget). Anyways the tech there told me that changing around the connections for the magnets will help prolong the life of the unit. ...
Forum: FC (Forward Control Unique Issues) 12-11-2012
Replies: 14
Views: 9,478
Posted By ryoung
Yup, snow. Not sure if you have ever been where...

Yup, snow. Not sure if you have ever been where there has been 11 ft of snow, but it is quite an experience. We love to snowmobile. When there is that kind of powder it is like driving a sea-doo. ...
Forum: FC (Forward Control Unique Issues) 12-11-2012
Replies: 14
Views: 9,478
Posted By ryoung
Napa Pricing

One thing to remember is that I am in Canada. I do have an account at Napa as I do alot of car repairs. That being said, parts are roughly half price at any NAPA United States store without my...
Forum: FC (Forward Control Unique Issues) 12-10-2012
Replies: 14
Views: 9,478
Posted By ryoung
Facet Fan and Clutch Bearing Replacement

My facet fan was a little noisy so I decided to take it apart and rebuild anything I could. I discovered the bearing that is pressed in the clutch fan hub was bad. It is an uncommon size, 30mm x 55mm...
Forum: Parts and Other Items For Sale 11-17-2012
Replies: 1
Views: 886
Posted By ryoung
Air horn

I have an air horn from a roughly 76 Wanderlodge, just the piece that always gets bent. It is 23 inches long. I have a 81 Wanderlodge and that piece is alot longer. If anyone wants it I will send...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 11-14-2012
Replies: 9
Views: 1,287
Posted By ryoung
It is but I am afraid that even running it for a...

It is but I am afraid that even running it for a couple of seconds could destroy the compressor if there is no freon in there as there would be no lubricant. I am curious if it is acceptable just to...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 11-14-2012
Replies: 9
Views: 1,287
Posted By ryoung
Thanks for the starting points. I am sure there...

Thanks for the starting points. I am sure there is no freon in the system. Does anyone know if there is a way to check to see if the compressor is good with no freon in the system?
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 11-14-2012
Replies: 9
Views: 1,287
Posted By ryoung
Cruise Air Repair

So over the winter I am looking to repair 2 of my 3 Cruise Airs. I was thinking of putting roof units in but am not a fan of cutting into a perfectly good non leaking roof. As I am not an AC guy,...
Forum: FC (Forward Control Unique Issues) 07-25-2012
Replies: 27
Views: 2,461
Posted By ryoung
Battery Tray

When I rebuilt mine 6 years ago I used angle iron for the sides, paintedthem with about 6 coats of rust resistant paint, then used a peice of 3/4" pressure treated wood for the bottom. So far so...
Showing results 1 to 25 of 141

 
Forum Jump
Web Search:

All times are GMT -4. The time now is 10:58 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.