Wanderlodge Owners Group  
BuyByeBlueBird.com
Donate

Go Back   Wanderlodge Owners Group > Search Forums

Site Search:
Showing results 1 to 25 of 522
Search took 0.02 seconds.
Search: Posts Made By: Mikenjackie
Forum: Electrical 4 Days Ago
Replies: 20
Views: 600
Posted By Mikenjackie
LED tape vs replacement tubes

I’m getting ready to upgrade my fluorescent lights to LED. I’ve seen both LED tubes that replace the original units, & the adhesive backed LED tapes. Does anyone have recommendations as to which is...
Forum: Birds Of a Feather (BOF) 1 Week Ago
Replies: 76
Views: 10,069
Posted By Mikenjackie
A few pics of the chili pot luck...with a...

A few pics of the chili pot luck...with a lightshow put on by Mother Nature!
Forum: Generators 2 Weeks Ago
Replies: 4
Views: 178
Posted By Mikenjackie
Thanks, Harold. I replaced the air filter in the...

Thanks, Harold. I replaced the air filter in the spring but I'll check it this evening. Actually, as I write this, the generator smoothed out & smoke stopped, now just an occasional puff. I'll let it...
Forum: Generators 2 Weeks Ago
Replies: 4
Views: 178
Posted By Mikenjackie
Black exhaust!

Started the genny up this morning, first time for months, it's running, but rough, with lots of black exhaust smoke. Is this indicative of a bad fuel filter? On the way to Q, haven't had time to...
Forum: Birds Of a Feather (BOF) 3 Weeks Ago
Replies: 76
Views: 10,069
Posted By Mikenjackie
Q20??? Has the SP38 mastered time travel:D:D? ...

Q20??? Has the SP38 mastered time travel:D:D?

See ya down there soon...we're leaving Sunday, taking a leisurely trip, expect to be there around the 10th or so.
Forum: Engine 4 Weeks Ago
Replies: 17
Views: 634
Posted By Mikenjackie
I had the same issue with my PT-40 during/after a...

I had the same issue with my PT-40 during/after a cold snap (teens). I'd wait till the engine was warm, then loosen, twist round the clamp 10-15 degrees or so (depending on access) then re-tighten....
Forum: General 12-22-2019
Replies: 13
Views: 533
Posted By Mikenjackie
Our Sharp convection microwave has a fixed rack...

Our Sharp convection microwave has a fixed rack for convection only & a little metal platform which can be used for either. The thing we've found we need to watch out for is that some of the menu...
Forum: Under The Awning 12-21-2019
Replies: 14
Views: 487
Posted By Mikenjackie
Had the same issue last winter. After thinking...

Had the same issue last winter. After thinking about it, I cut off the hose, poured boiling water over the end to get the bayonet connector off. Did it that way, 'cos I couldn't think of any way to...
Forum: Electrical 12-20-2019
Replies: 7
Views: 320
Posted By Mikenjackie
I don't know if the PT-38 is the same as the...

I don't know if the PT-38 is the same as the PT-40, but on mine, if you opened the curb-side doors, there was a closet. On the right wall of the closet was a small access hatch. The hatch gave...
Forum: Electrical 12-20-2019
Replies: 7
Views: 320
Posted By Mikenjackie
On my PT-40, a lot of the interior lights were...

On my PT-40, a lot of the interior lights were 12v. I had one of the c/b's pop on the inverter, which caused a lot of the interior lights to fail. Real hard to get to the c/b's, on mine they were...
Forum: Coaches For Sale by WOG Members 12-20-2019
Replies: 16
Views: 2,341
Posted By Mikenjackie
Going to miss you both...hope you come to your...

Going to miss you both...hope you come to your senses & get another 'Bird SOON; after all you've drunk the Kool-Aid, you won't be able to stay away too long:D:D. Seriously, if you visit Q in...
Forum: General 12-13-2019
Replies: 9
Views: 741
Posted By Mikenjackie
I knew mine was shot when I pressed on the...

I knew mine was shot when I pressed on the Schrader valve on top of the accumulator & water sprayed out:eek::cool:. I just removed the accumulator, & while I was at it, put in a higher-flow water...
Forum: General 12-10-2019
Replies: 9
Views: 473
Posted By Mikenjackie
Thanks, Bruce & Randy, that's probably what I'll...

Thanks, Bruce & Randy, that's probably what I'll do. DW wants the edges binded (bound??), didn't know you could get it done or do it yourself.
Forum: General 12-10-2019
Replies: 9
Views: 473
Posted By Mikenjackie
Source for dash cover

Has anyone found a source for dash covers, preferably made of some kind of carpet-type material? The dogs love to lay on the passenger side while we're camped, & I'm afraid the pleather covering will...
Forum: Travel Tips - Fuel Prices 12-08-2019
Replies: 90
Views: 8,760
Posted By Mikenjackie
Hadn't tried the commercial pumps till I got the...

Hadn't tried the commercial pumps till I got the TSD card. Love, love, love it:):)!Way faster than the regular pumps (no burping, probably due to dual fill on the bus), don't have to re-do the card...
Forum: Birds Of a Feather (BOF) 11-15-2019
Replies: 76
Views: 10,069
Posted By Mikenjackie
Allison mod at Q?

I need to get the Allison transmission modification done (so it doesn't go straight into 4th gear when the retarder is on). Is there a place at/near Quartzsite that does this, and if so, would there...
Forum: General 11-12-2019
Replies: 2
Views: 202
Posted By Mikenjackie
Potable water freezing up

I don't know if anyone else has had this problem. Last night the temp was in the single digits, & this morning our water isn't running. The Aquahot is working, the bay where the waterpumps are is...
Forum: General 11-11-2019
Replies: 19
Views: 999
Posted By Mikenjackie
Our PT-40 only had a couple receptacles powered...

Our PT-40 only had a couple receptacles powered by the inverter while driving; the ones in the galley, microwave & ice maker. The ice maker one was in behind the false back of the cupboard under the...
Forum: Birds Of a Feather (BOF) 10-20-2019
Replies: 76
Views: 10,069
Posted By Mikenjackie
Can't wait for Q14, please sign us up, last year...

Can't wait for Q14, please sign us up, last year (our first) was such a blast! Also planning on the Mexico trip afterwards.
Forum: Electrical 10-20-2019
Replies: 4
Views: 408
Posted By Mikenjackie
Our '88 PT-40 had microwave, both TV's, ice maker...

Our '88 PT-40 had microwave, both TV's, ice maker & outlet in the kitchen area controlled by the inverter. It had two almost impossible-to-get-to circuit breakers, accessible (sort of!) through a...
Forum: Buying a Wanderlodge, a Bluebird or any RV 10-17-2019
Replies: 12
Views: 1,091
Posted By Mikenjackie
Shawn, If you can wait a couple months, the...

Shawn,

If you can wait a couple months, the 2nd largest WOG rally is in January at Quartzsite, AZ...last year there were about 100 rigs there.

Here's the reality; you really do need to keep...
Forum: Under The Awning 10-12-2019
Replies: 17
Views: 948
Posted By Mikenjackie
I recently "went to the dark side" as it were, &...

I recently "went to the dark side" as it were, & joined the FB group. For the most part, it's mainly "under the awning" type stuff, but when somebody posts a problem, almost always someone posts back...
Forum: Engine 10-10-2019
Replies: 27
Views: 1,997
Posted By Mikenjackie
I had a "no crank" issue intermittently on my '88...

I had a "no crank" issue intermittently on my '88 PT-40 (8v92 mechanical). If the batteries were bad, it would "try" to crank, but Yves, you said no power to starter. Mine turned out to be the braid...
Forum: M380 (Unique Issues) 10-09-2019
Replies: 12
Views: 1,014
Posted By Mikenjackie
Just had the same problem on my WB43 mid-entry...

Just had the same problem on my WB43 mid-entry (lucite handle stress cracks led to breakage). My handle's on the left side of the door & has 5 screw mounts, but has the same overall dimensions as the...
Forum: Electrical 10-03-2019
Replies: 18
Views: 1,101
Posted By Mikenjackie
Going back to the TV problem, on my PT-40, the...

Going back to the TV problem, on my PT-40, the front TV, ice maker & microwave all ran off the inverter, & it needed to be on for them to work...
Showing results 1 to 25 of 522

 
Forum Jump
Web Search:

All times are GMT -4. The time now is 02:01 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.