Wanderlodge Owners Group  
BuyByeBlueBird.com
Donate

Go Back   Wanderlodge Owners Group > Search Forums

Site Search:
Showing results 1 to 25 of 86
Search took 0.01 seconds.
Search: Posts Made By: WarrenM
Forum: General 6 Days Ago
Replies: 1
Views: 132
Posted By WarrenM
I used 3M Strip Caulk on the Dupree valve...

I used 3M Strip Caulk on the Dupree valve housings when I removed/repaired the tanks. I believe that originally the factory used “Dum-Dum”, which has been discontinued. If the plastic is good on...
Forum: General 11-01-2018
Replies: 4
Views: 383
Posted By WarrenM
Thanks for the insight and experience. Always...

Thanks for the insight and experience. Always better, for me anyway, to ask for direction before utilizing undo force.
Forum: General 11-01-2018
Replies: 4
Views: 383
Posted By WarrenM
Thinlite Lens Removal

Being manually and mechanically challenged, most of the time; I am trying to find the method for removing the lens of the “ThinLite” fluorescent fixtures. I’m thinking it would be flexing the sides...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 10-05-2018
Replies: 14
Views: 793
Posted By WarrenM
SOLVED — “Occam’s Razor” prevails. The Aqua Hot...

SOLVED — “Occam’s Razor” prevails. The Aqua Hot appears operational with the cycling of the “Hydronic Heat” switch on the dash.
Thanks to one and all for your, time, knowledge and willingness to...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 10-05-2018
Replies: 14
Views: 793
Posted By WarrenM
Thanks Bill, I have the manual(s) paper and...

Thanks Bill, I have the manual(s) paper and .pdf’s, some of which may have caused confusion on my part. The journey on the troubleshooting tree begins.
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 10-04-2018
Replies: 14
Views: 793
Posted By WarrenM
The diesel mode was not active during the low...

The diesel mode was not active during the low voltage situation. I will try using the switch to initiate a “reset”. The reference I read utilized a toothpick through a hole to initiate the reset,...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 10-04-2018
Replies: 14
Views: 793
Posted By WarrenM
After experiencing a “low voltage” situation with...

After experiencing a “low voltage” situation with bad batteries, the Aqua Hot ceased to do anything but electrically heat water. No pumps, no fans, 12 volt functions, etc. From what I can...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 10-04-2018
Replies: 14
Views: 793
Posted By WarrenM
I’ll look toward the burner control for my...

I’ll look toward the burner control for my solution, if it is the only apparent controller. Back to the manual and troubleshooting trees.
Thanks for your help.
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 10-04-2018
Replies: 14
Views: 793
Posted By WarrenM
That’s good to know. I’ll be labelling as I go. ...

That’s good to know. I’ll be labelling as I go.
Still looking for the “brain board” for the Aqua Hot, any ideas or paths would be appreciated. The burner control box is the only apparent...
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 10-04-2018
Replies: 14
Views: 793
Posted By WarrenM
Aqua Hot Reset - SOLVED!

Buried in the manuals I found a reference to a “reset” after a low voltage situation. I am trying to locate this control board. I have found this unmarked box in the same bay. Could this contain...
Forum: General 09-23-2018
Replies: 3
Views: 410
Posted By WarrenM
Brian, I don’t know about the frequency of oil...

Brian, I don’t know about the frequency of oil and filter changes, but as long as the oil meets the ISO criteria of Rando HD32, it should be OK to use. There are several tables showing substitutions...
Forum: General 09-22-2018
Replies: 15
Views: 680
Posted By WarrenM
I think it was a “nice” idea, wrong place, wrong...

I think it was a “nice” idea, wrong place, wrong size and practically awkward most of the time (how often do the pumps fail?).
Forum: General 09-21-2018
Replies: 15
Views: 680
Posted By WarrenM
Thank you one and all for your information. The...

Thank you one and all for your information. The isolation of the pumps for replacing is nice, however, the access that this plate blocks makes keeping it a toss-up. Removing the common wall for the...
Forum: General 09-21-2018
Replies: 15
Views: 680
Posted By WarrenM
Yes, while going over the systems with Royal in...

Yes, while going over the systems with Royal in 2012, my notes state that he never used the panel and was “hazy” about it’s purpose.

This has only become an issue since it began leaking, and the...
Forum: General 09-21-2018
Replies: 15
Views: 680
Posted By WarrenM
I understand what the CPVC manifold is and how it...

I understand what the CPVC manifold is and how it functions. The panel that I am asking about is on the other side of the bus (curbside), in the same space as the water pumps, expansion tank,...
Forum: General 09-21-2018
Replies: 15
Views: 680
Posted By WarrenM
This panel is curbside, one bay forward of the...

This panel is curbside, one bay forward of the holding tanks . There is a CPVC manifold, 2 bays forward on the streetside.
I don’t really understand it’s purpose. It blocks access to pumps,...
Forum: General 09-21-2018
Replies: 15
Views: 680
Posted By WarrenM
Does your reply mean that this is a “new” item? ...

Does your reply mean that this is a “new” item? It seems to be factory installed. Do you know what the “purpose” may be for this assembly? Can I by-pass this with several tees and not disrupt any...
Forum: General 09-20-2018
Replies: 15
Views: 680
Posted By WarrenM
Water Pump Valve Panel?

I am trying to determine the function of this panel. According to labels, it controls the suction and pressure hose for each pump. Is this to help prime a pump, winterize system??????? Right now...
Forum: 'Bird Projects & Modifications 07-22-2018
Replies: 182
Views: 21,827
Posted By WarrenM
Kev, have you considered a closed-cell “Pool...

Kev, have you considered a closed-cell “Pool Noodle” piece? Tape it from the back.
Forum: 'Bird Projects & Modifications 06-25-2018
Replies: 182
Views: 21,827
Posted By WarrenM
I replaced the upper and lower drain clip prior...

I replaced the upper and lower drain clip prior to installing my RF197 as a preventative measure. So far so good.
Forum: General 06-22-2018
Replies: 6
Views: 508
Posted By WarrenM
Hi Dennis, you might also check to see if the TV...

Hi Dennis, you might also check to see if the TV has a “demo” setting in the brightness &/or contrast menu. This should give you the 6500Kelvin setting you see in the stores. It does tend to...
Forum: General 06-16-2018
Replies: 3
Views: 362
Posted By WarrenM
Thanks Chap and John for your information. I...

Thanks Chap and John for your information. I guess another sensor can’t hurt, safeguards against excessive heat are a good thing.
Forum: General 06-15-2018
Replies: 3
Views: 362
Posted By WarrenM
Identify sensor/stat?

While stumbling through my refrigerator changeout I found this sensor at the top of the outside vent door opening. My assumption is that it is a temperature set-point sensor for a overheat/fire...
Forum: General 05-27-2018
Replies: 8
Views: 560
Posted By WarrenM
Many thanks to those who pointed me in the right...

Many thanks to those who pointed me in the right direction (Battery Shunt Panel). Drawing #6088298 “Diagram, Wiring, Charging Circuit” supplied the information and overall view. I was locked off...
Forum: General 05-23-2018
Replies: 8
Views: 560
Posted By WarrenM
Thanks Mose, that helps to corral the location. ...

Thanks Mose, that helps to corral the location. My shunt panel is similar. I believe that the circuit will be terminated at a secondary fuse block for 12 volt access points in the curbside bays.
Showing results 1 to 25 of 86

 
Forum Jump
Web Search:

All times are GMT -4. The time now is 03:31 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.