Wanderlodge Owners Group  
BuyByeBlueBird.com
Donate

Go Back   Wanderlodge Owners Group > Search Forums

Site Search:
Showing results 1 to 25 of 98
Search took 0.01 seconds.
Search: Posts Made By: schipperkejoe
Forum: Generators 08-23-2017
Replies: 5
Views: 772
Posted By schipperkejoe
The fuel shut off gets power through the switch...

The fuel shut off gets power through the switch when you crank the engine. Once the engine is running, the power to it is held by a circuit that goes through several sensors, low coolant (up by the...
Forum: Generators 08-23-2017
Replies: 5
Views: 772
Posted By schipperkejoe
New lines so there is no possible air leak. ...

New lines so there is no possible air leak. Bleed the fuel line to the injectors, there's a little petcock (bypass) you open while the pump is clicking and shut before you let the pump stop. It's a...
Forum: Ladies General Discussion 01-20-2017
Replies: 16
Views: 3,165
Posted By schipperkejoe
Must have been a **** of a corner! Would love...

Must have been a **** of a corner!
Would love to see the video.
Forum: Engine 01-20-2017
Replies: 25
Views: 2,765
Posted By schipperkejoe
I've been at WW Williams in Tucson, pretty high...

I've been at WW Williams in Tucson, pretty high priced my opinion. If your going to Tucson, check Global Industrial Automatics.
For an exhaust manifold, any good big equipment mechanic can do the...
Forum: Engine 01-19-2017
Replies: 25
Views: 2,765
Posted By schipperkejoe
In Tucson. Global Industrial Automatics. ...

In Tucson.
Global Industrial Automatics.
They were working on older Detroit engines, but that was 2 years ago.
Highly recommended if your Allison Tranny takes a poop like mine did.
The gasket...
Forum: Most Frequently Asked Questions About Operating Systems 11-28-2016
Replies: 48
Views: 10,452
Posted By schipperkejoe
Lesson told me many years back. Don't...

Lesson told me many years back. Don't continuously crank on the cold engine. First, it won't start, second it is tough on the starter, third it drains the battery quicker.
If you have to try and...
Forum: Generators 03-12-2015
Replies: 13
Views: 1,936
Posted By schipperkejoe
If you keep having the problem, try jumping the...

If you keep having the problem, try jumping the low oil pressure switch. According to powertech the switch is a relatively common problem. Solved my problem anyway.
Forum: HVAC, Air Conditioners, Aqua Hot, Primus, Webasto, Chassis Heaters, Furnaces and Water Heaters 03-11-2015
Replies: 33
Views: 6,944
Posted By schipperkejoe
Joe - sounds interesting. The controls for the...

Joe - sounds interesting. The controls for the two loops on the Chickadee don't make much sense when you look at their location and what they do. Both are on one side of the bus for one thing, both...
Forum: Engine 03-11-2015
Replies: 5
Views: 1,690
Posted By schipperkejoe
A couple months ago, I had the same experience,...

A couple months ago, I had the same experience, minus the air leak. I had the same codes for coolant temp, coolant level and engine voltage. Also had the engine shut down several times on a two...
Forum: Electrical 01-31-2015
Replies: 6
Views: 1,164
Posted By schipperkejoe
Might add - - When checking the gauge readings...

Might add - - When checking the gauge readings use your handheld meter to measure voltage at the dash voltmeters. Then compare what the hand held meter says with the dash gauge. That way you don't...
Forum: Electrical 01-31-2015
Replies: 6
Views: 1,164
Posted By schipperkejoe
This pertains to a WB40, I'm assuming it's...

This pertains to a WB40, I'm assuming it's similar to the WB42.

The volt meters pick up off two circuits controlled by circuit breakers, and not off the bus bars in the breaker panel. If...
Forum: Generators 12-19-2014
Replies: 8
Views: 2,516
Posted By schipperkejoe
I'll email you pics of the sending unit and only...

I'll email you pics of the sending unit and only two switches I've found in a PM.
Tried to put them in here but this site wanted to know where in the Ural Mountains the pictures are. I didn't know...
Forum: Generators 12-17-2014
Replies: 8
Views: 2,516
Posted By schipperkejoe
Ohm match with the gage is the exact problem of...

Ohm match with the gage is the exact problem of finding a sending unit. I couldn't find a ohm rating to match the Teleflex gages until I went around the circular question route a couple times. ...
Forum: Generators 12-16-2014
Replies: 8
Views: 2,516
Posted By schipperkejoe
More PowerTech 15kw ??

I've read lots of old posts about these gensets and their parts. But I don't see the answer to some of my issues. Started with two issues, temp gage doesn't work and the genset stops periodically...
Forum: Electrical 11-16-2014
Replies: 698
Views: 95,882
Posted By schipperkejoe
True, but the concept is the same. Low voltage...

True, but the concept is the same. Low voltage through sensors will give variable and unreliable readings. His speedometer and tach were bouncing around, an indicator of voltage drop. They're...
Forum: Electrical 11-15-2014
Replies: 698
Views: 95,882
Posted By schipperkejoe
Second thought. DDEC (Detroit Diesel Electronic...

Second thought. DDEC (Detroit Diesel Electronic Control) and ATEC (Alison Transmission Electronic Control) pick up their power source from the engine batteries. The speedometer gets it's input from...
Forum: Electrical 11-15-2014
Replies: 698
Views: 95,882
Posted By schipperkejoe
Mike - if you look back a ways you'll see I had...

Mike - if you look back a ways you'll see I had plenty of problems with this issue.
Look at the volt meter on the dash, and see if the voltages change when you push the connection switch. In my...
Forum: Electrical 11-08-2014
Replies: 54
Views: 6,670
Posted By schipperkejoe
So here's the latest. Joe Garner was kind...

So here's the latest.

Joe Garner was kind enough to stop overnight here in Fredericksburg TX to offer assistance. He had the DDEC boxes with him. Most of the codes recorded were old, some as...
Forum: Electrical 11-06-2014
Replies: 54
Views: 6,670
Posted By schipperkejoe
Thanks "Tweet Dreams". I'll try connecting the...

Thanks "Tweet Dreams".
I'll try connecting the two wires together if I need to bypass it.
If I successfully move tomorrow, I've got a week to mess with it before the next dentist trip. Thanks...
Forum: Electrical 11-06-2014
Replies: 54
Views: 6,670
Posted By schipperkejoe
coolant level is above the sensor about 3 inches...

coolant level is above the sensor about 3 inches cold.
One wire to sensor was not tight and connection showed corrosion. Could not find any other suspicious connections Cleaned the connection and...
Forum: Electrical 11-05-2014
Replies: 54
Views: 6,670
Posted By schipperkejoe
**** of a day. 3 trips to the dentist (total 4...

**** of a day. 3 trips to the dentist (total 4 hrs), 2 trips to the drug store, and it peed rain all day. As a result, didn't even look at the bus.
Will make sure on the coolant level tomorrow,...
Forum: Electrical 11-04-2014
Replies: 54
Views: 6,670
Posted By schipperkejoe
Can't say on the turn signals. When the...

Can't say on the turn signals. When the emergency flashers were on it seemed to make things worse.

Codes
16 coolant sensor high voltage
36 oil pressure low voltage
43 low coolant...
Forum: Electrical 11-04-2014
Replies: 54
Views: 6,670
Posted By schipperkejoe
Will show my ignorance---how do I get a code,...

Will show my ignorance---how do I get a code, there's no screen to get one on.
Parked and shut down for the night.
Heck of a toothache and have a dentist for morning.
Not one of my better days!
Forum: Electrical 11-04-2014
Replies: 54
Views: 6,670
Posted By schipperkejoe
Similar problem, and Need some help, stranded in...

Similar problem, and Need some help, stranded in Fredericksburg, TX. Check engine light came on. it was on and off depending on throttle setting and load. Then tach reading went to 0 and stop...
Forum: Generators 10-22-2014
Replies: 9
Views: 2,394
Posted By schipperkejoe
Figure this is a good thread to tie into. I've...

Figure this is a good thread to tie into. I've got the MH15 PowerTech generator like lots of others. Mine will start and run great but shut off for some unknown reason. Oil pressure is good, no...
Showing results 1 to 25 of 98

 
Forum Jump
Web Search:

All times are GMT -4. The time now is 10:21 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.