View Single Post
Old 01-02-2010
Ernest Ekberg's Avatar
Ernest Ekberg Ernest Ekberg is offline
Senior Member
Join Date: May 2009
Location: Weatherford, Tx
Posts: 5,954

Ok- here is what I do. I glue down the wood with Bosticks best adhesive. It now comes in 2 gallon pails which are easier to handle.
The initial few wood runs are critical as you need to figure out where you are going to start. Outline those areas with a marker. Label the pieces of wood and trowel the adhesive inside the marked area. Install the wood and press down as hard as you can to insure a good transfer. Let it stand over nite- with weight on it. I use a box of wood or toolbox.
When you come back the next day, you will have a firm footing to install your next pieces.

If you don't let it set, and try to do too much, the wood will slide all over the place.

These directions are easier to read then the actual installation.
Ernie Ekberg
Prevost Liberty 45 XL
Reply With Quote