View Single Post
Old 08-21-2010
GregOConnor's Avatar
GregOConnor GregOConnor is offline
Senior Member
Join Date: Jan 2010
Location: Romoland
Posts: 86

these test only show issue if the appliance with a fault is plugged in or turned on. its a false sense of security. I test my pool lite with a tennis ball. Its hard to get onw of my rots to open the door by tossing a ball in the bus.
The do not bond neutral to ground in the bus rule is only true fro shore power. when on inverter or genset the bus is bonded onboard for those circuits. I see a prob here for folks who dont set it up correctly with aftermarket mods.

I never understood the Lost Neutral issue and asked a underwriters lab engineer to explain the lost neutral dynamic. simple but it requires a diagram to explain. this would be a good point for you guys to go over. there may be a vid or diagram some place
Greg O'Connor
Romoland, CA
1994 wb40
Reply With Quote