'89 PT36 blocked Paddle in the dump water valve

[jduntech]

you need to put a threaded rod into the valve, use a steel plate with a hole in it over the rod, then use a hex nut on the rod to pull the valve out, could possibly destroy valve but you have no choice

[RAMiREZ]

Originally Posted by jduntech

you need to put a threaded rod into the valve, use a steel plate with a hole in it over the rod, then use a hex nut on the rod to pull the valve out, could possibly destroy valve but you have no choice

I already thought that. But in case it doesn't work, I need a replacement.

thanks Ramin

[Chief607]

I too have the air cylinders. As a tip, Once a year I purchase the tune up kit (new paddle and O rings) from Dupree products. I pull the old ones out and install the new ones. Use a long screw driver and an old rag to clean any junk out of the groves on the bottom. apply plumbers grease to the new one and reassemble. so far no problems.

[Darryl]

Has anyone swapped out the paddles on the gray water tank on an FC? Any suggestions?

Darryl

[Dieselbird01]

Originally Posted by RAMiREZ

GREAT - THANK YOU for offering me your help!

I'm still looking for one more rubber and a replacement paddle!
Does somebody has any idea Where to get?

regards
Ramin

Originally Posted by badandy

If anyone has these parts to spare and can send them to me I'll send them all at once to Germany. I only have the 1 rubber thingy.

Hi Ramin,

It's not new but if it will help get you going (pun intended), I have a reasonably clean "used" paddle with reasonably clean "used" rubber seals that you can have (if you want it)... I can send it to Andy if he PM's me his mailing address.

[Darryl]

I thought bad Andy had this taken care of. I can check my bus later.

Darryl

[Darryl]

I have a new one with o’rings ready to go. Please send an address.

Darryl

[Darryl]

Ramin and Andy
You can contact me at dhammock@weldmold.com with an address. When Stephen's open again I'll get a new one and let you know the price.

Darryl

[badandy]

I just emailed you my address.

[Dieselbird01]

Originally Posted by badandy

I just emailed you my address.

Hi Andy,

Ramin sent me a PM requesting the used paddle that I have so I also need your address.