Hydralift motorcycle lift for sale

[Randy Dupree]

Used Hydralift bike lift.
The lift is in good condition and has a new motor on it.
I removed it from a wanderlodge and can ship it anywhere.
Located in Bainbridge Ga and we even have the brackets that weld to the bus frame.
$2500 plus shipping.
352 538 3435

[Mike Hohnstein]

I bought one of those from a WL member, can't recall who. Cautioned him on packaging, didn't pay attention, all I got was the ramp, seriously, every thing else fell off the pallet. Surprised the shipper even loaded it. Still got the ramp some where. Seller lost, not me.

[Randy Dupree]

My stuff does not fall of the pallet.
You didn't buy it from me,right?
hahaa!

[NoGas]

That’s a good deal. Unfortunately and for our new M380 owners: Hydralift Not Recommended for the M380

[GregOC]

I have a Harley lift (manual pump hoist) I took off of a GMC for $800. won't fit most of the pushers because the ram obstructs the rear gate. one design flaw with my lift I see is the ram stroke stays exposed during storage then when retracted, the petina cuts the ram seal. when stored owner should disconnect then retract the ram. simple design and robust build so you can still pull a car. Hydro-lift is probably the only way to add a motorcycle carrier to a pusher and still open the rear gate. not sure why the other post give warning about the 380?. I took this HarleyLift off of a GMC classic project. https://inlandempire.craigslist.org/...873828198.html

[AnFear]

Well I drove down to Bainbridge and bought this Hydralift. Randy helped me load it into my trailer with his forklift. Now I just need to have it installed. Pleasure doing business with you, thanks.

[irmagoo]

Originally Posted by AnFear

Well I drove down to Bainbridge and bought this Hydralift. Randy helped me load it into my trailer with his forklift. Now I just need to have it installed. Pleasure doing business with you, thanks.

my big buddy jim walters hand loaded and unloaded one for me-and we are both git'n long in the tooth...
if i had him around when we were young....
neither one of us would be walk'n now:eek

[AnFear]

Yeah, it's not all that heavy but it's awkward to move

[irmagoo]

Originally Posted by AnFear

Yeah, it's not all that heavy but it's awkward to move

about 350 lbs. i might be able to roll it

[isp2952]

Originally Posted by irmagoo

my big buddy jim walters hand loaded and unloaded one for me-and we are both git'n long in the tooth...
if i had him around when we were young....
neither one of us would be walk'n now:eek

Well Mike, that was a while ago when I still had it in me to load and unload that thing myself. I think those days may have come and gone I will say this, I just got back from Pasadena, Ca. from moving my aunt and I still had a little left in me, that I didn't know was still there.